Catalogue (1.8 MB)

Related Products

Enabling Switch ZA3

Enabling Switch ZA5


Enabling Switch ZB1


Enabling Switch ZB2


Do you have any questions concerning our products?

Contact us :

Tel:  +49 40/538092-50
Fax: +49 40/538092-85

Enabling Switches Accept-A ZA2

  • 3-stage switches (Off-On-Off)
  • Ideal as enabling switch on input devices
  • Redundant contacts to fulfil safety category 4
Technical Caracteristics
Protection DegreeIP65(with rubber cap)
Operating Temperature -25°C ... +60°C
Mechanical Lifetime

1 Mio. activations

Operating Contacts2
Auxiliary Contacts0-2


The B-COMMAND enabling switch ZA2 is a three-stage (OFF-ON-OFF) enabling switch which is ideal for installation on input devices. The two working contacts are change-over contacts, which offer the customer several possibilities for wiring.

The redundant contact configuration meets safety category 4. In addition to the two normally open contacts (forced-opening) as auxiliary contacts offer options for monitoring or additional functions.

For optimum operating comfort the actuation force from position 2 to 3 for centric and eccentric pressure is absolutely identical: even switching with only one finger at the outer limit of the actuatur is reliably possible.

The B-COMMAND enabling switches ZA2 are available with or without rubber caps. In addition to the standard ruber cap color yellow, B-COMMAND can also supply the enabling switch ZA2 with grey or black rubber cap. To enable the use of B-COMMAND enabling switches in the automotive industry, our enabling switches are also available in silicone-free material.


If you have any questions regarding our enabling switches we are available for you by phone, e-mail or live-chat.

3-Stage Operation Enabling Switches (IEC 60947-5-8)

The function of our enabling switches is 3-stage or based on 3 positions. The working contacts are actuated in the middle position. For this purpose, we have implemented a clearly noticeable pressure point on the design side. In the event of panic / injury, the operator would either press firmly (3rd stage) or release the handle (1st stage). Both times the working contacts would be deactivated and the system would be stopped. The 2nd stage must therefore be actively operated and held. It is mainly used for setting up or maintaining machines or robots within hazardous areas.